Assembly instructions and filling information for the twisterband energy chain system

Vui lòng chọn địa điểm giao hàng của quý khách

Việc chọn trang quốc gia/khu vực có thể ảnh hưởng đến các yếu tố như giá, các lựa chọn vận chuyển và sự sẵn có của sản phẩm.

Hiển thị tất cả các vị trí

Đến www.igus.com

Xuất kho trong vòng 24 giờ Tính tuổi thọ của sản phẩm khi sử dụng Tải trực tiếp bản CAD về máy của bạn

myigus

Giỏ hàng

(0)

Liên hệ

igus® Vietnam Company Limited

Unit 4, 7th Floor, Standard Factory B, Tan Thuan Export Processing Zone, Tan Thuan Street

District 7, HCM City, Vietnam

+84 28 3636 4189

Gửi tin nhắn

Xem tất cả liên hệ

VN(VI)

twisterband

Installation guide for twisterband

TPE outer jacket

Dimensioning: Cable selection

When selecting cables, pay particular attention to good abrasion and gliding properties. An ideal jacket material is TPE.
Recommendation: chainflex® cable CF9

Special shielded cables for the use in twisterband are in preparation. Please contact us if the use of shielded cables is essential

Dimensioning: Filling

twisterband-Version with lock:
TB20.44.18.x.01.0 | TB30.75.22.x.01.0

A = separate cables with crossbars

B = Insert cables sorted according to diameter or bending radius. Insert thin, small ones inward – then increasingly bigger ones outward.

C = Not more than two cables on top of each other. 10% of the larger diameter or a minimum of 1 mm between all cables

D = 10% of the larger diameter or a
minimum of 1 mm between all cables

E = 10% of the larger diameter or a
minimum of 1 mm between all cables and separators

twisterband version with easy locking:
TB12.23.09.x.01.0 | TB20.44.12.x.01.0

A = insert cables sorted according to diameter or bending radius. Insert thin, small ones inward – then increasingly bigger ones outward.

B = A minimum of 1 mm or 10% of the larger diameter => Ø B between all cables

C = Not more than 2 cables on top of each other. A minimum of 1 mm or
10% of the larger diameter between all cables

Assembly: Mounting brackets

1. Insert twisterband between the steel parts.

2. Secure the twisterband by screwing the mounting bracket in place.

Assembly: guide shaft

Insert a centric shaft as a guide for vertical installation orientations starting at 1500° rotation angles.

Generally, insert a centric shaft as support for horizontal installation orientations.

Assembly: Strain relief

- Strain relief the cables on both ends
- Ensure that the cable tie lock does not point in the direction of the energy chain

Final position:

The twisterband must not be twisted up to the end. To avoid excessive strain on the cables, a min. reserve of 90° must be planned in front of each mounting point.